Descargar Imprimir esta página

KitchenAid 720-0954L Instrucciones De Instalación Y Manual De Uso Y Cuidado página 48

Publicidad

Idiomas disponibles

Idiomas disponibles

Prepare the Grill for Lighting
1.
Open the hood completely. Do not light burners with the
hood closed.
Make sure control knobs are turned to " ○ ".
2.
3.
The grease box must be in place and push all the way to
back.
A. Grease Box
Turn the Gas Supply On
1.
For outdoor grills using a 20 lb LP gas fuel tank:
Slowly open the tank valve.
NOTE: If the flow limiting device activates, your grill may
not light. If your grill does light, the flames will be low and
will not heat properly. Turn tank valve and all control knobs
off and wait 30 seconds. After shutting off the tank, very
slowly open tank valve and wait 5 seconds before lighting.
2.
For outdoor grills using gas supply source other than a 20
lb LP gas fuel tank:
Open the manual shutoff valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
A. Closed valve
B. Open valve
Lighting the Grill Burners
IMPORTANT: If the burner does not light immediately, turn the
burner knob to "○" and wait 5 minutes before relighting.
1.
Open the hood completely. Do not light burners with the
hood closed.
2.
Do not lean over the grill.
3.
Select the burner you want to light. Push in and turn the
grill burner control knob to "
in.
", while continuing to hold it
You will hear the "snapping" sound of the spark. When the
4.
burner is lit, release the knob. Turn knob to the desired
setting.
5.
Repeat for each of the other burners as needed.
Manually Lighting Grill Burners
1.
Open the hood completely. Do not light burners with hood
closed.
2.
Do not lean over the grill.
3.
Remove the manual lighting extension (see following
illustration) and attach a match to the split ring.
A
4.
Strike the match to light it.
5.
Guide the lit match under the grill grate.
Push in and turn the burner knob to "
6.
closest to the lit match. The burner will light immediately.
When the burner is lit, turn the knob to desired setting.
7.
Repeat steps 2 through 6 for each main burner.
8.
Remove match and replace manual lighting extension on
the right-side panel.
IMPORTANT:
If the burner does not light immediately, turn the burner knob to
" ○ " and wait 5 minutes before relighting.
If any burners do not light after attempting to light them
manually, contact the Customer Service Center. See the
"Assistance" section.
48
" for the burner

Publicidad

loading

Este manual también es adecuado para:

730-0954l