RIDGID WD10500 Manual Del Usuario página 8

OPERATION
MOVING THE WET/DRY VAC (Fig. 9)
1. Should it become necessary to pick the Vac up to
move it: The Dust Drum Latch Handles located at
the bottom of the Latches.
2. To maneuver the Vac: The Powerhead Carry
Handle (C) on top of the Powerhead Assembly can
be used.
BLOWING FEATURE (Fig. 10)
Your Vac features a Blowing Port. It can blow sawdust
and other debris. Follow the steps below to use your
Vac as a Blower.
1. Locate the Blowing Port, at the rear of the Wet/Dry
Vac Powerhead Assembly (A).
2. Insert the Tug-A-Long Positive Locking Hose with
Dual-Flex End (E) into the Blowing Port.
3. (Optional) Attach the Extension Wand (G) to swivel
end of the Tug-A-Long Positive Locking Hose with
Dual-Flex (E). See Locking Accessories section
of this manual for instructions on connecting the
Locking Accessories.
4. Turn the Vac ON and you are ready to use your Vac
as a Blower.
5. To Remove Hose: Press the Hose Locking Tab and
pull the Hose Cuff straight out of the Blowing Port.
Always wear safety eyewear complying with ANSI
Z87.1 (or in Canada, CSA Z94.3) before using as
a blower.
Fig. 9
To reduce the risk of injury to bystanders, keep
(C)
them clear of blowing debris.
(A)
Wear a dust mask if blowing creates dust which
might be inhaled.
Dust Drum
Latch
Handle (2)
(B)
To reduce the risk of hearing damage, wear ear
protectors when using the Vac/Blower for extended
time or in a noisy area.
8
WARNING:
!
WARNING:
!
CAUTION:
!
CAUTION:
!
Blowing Port
Hose
Locking Tab
(E)
INSERT HOSE
Fig. 10
(A)
REMOVE HOSE