SE Electronics BL8 Manual Del Usuario página 5

Technical specifications
Capsule
Polar patterns
Frequency range
Sensitivity
Max. SPL (0.5% THD)
Equivalent noise level
Dynamic range
Signal-to-noise ratio
Low-cut filter
Attenuation pad
Powering
Electrical impedance
Recommended load impedance
Current consumption
Connectivity
Dimensions
Weight
Frequency Response
Powering
To ensure proper operation, your sE product requires a Phantom power source that provides 48 Volts
according to IEC 61938.
Please be aware that Phantom power cannot pass through TRS connectors. A balanced microphone
cable with XLR connectors at both sides is required to provide Phantom power to your sE product.
Hand-crafted small-diaphragm true condenser capsule
Half-cardioid
20 – 20,000 Hz
25 mV/Pa (-32 dBV)
143 / 153 / 163 dB
14 dB(A)
129 / 139 / 149 dB (0/10/20 dB attenuation pad)
80 dB
80 / 160 Hz, 6 dB/oct, switchable
10 / 20 dB, switchable
48 Volts according to IEC 61938
60 Ohms
>1k Ohms
5.0 mA
3-pin male XLR connector
139 x 95 x 28.5 mm (L x W x H)
5.47 x 3.74 x 1.12 in. (L x W x H)
538 g (18.98 oz.)
Risk of damage
Do not connect your sE product to any power supply other than a Phantom power
source (input with Phantom power or external IEC standard Phantom power
supply) with a floating connector, using a balanced cable with studio-grade
connectors to IEC 268-12 only. This is the only way to ensure safe and reliable
operation.
(0/10/20 dB attenuation pad)
SPL
5
Polar Pattern