Publicidad
Idiomas disponibles
Idiomas disponibles
HYDRAULIC COMPONENTS
1. Make sure all the components are clean and there are no external contaminations inside.
2. Connect hoses (pic. 1) and fulfi ll the pump (pic. 2)
3. During fi rst start-up run the pump with delivery pressure between 50 and 100 bar for at least 10 min.
4. Please adjust set-up according settings on page 7 if needed.
5. In case of low temperature the pump has to run without load until the oil reaches a proper viscosyt (fl uid page 6).
Filler cap
pic. 1
Displacement
Series
[cc]
60
90
PPV
110
130
Fluid
Mineral or synthetic compatible with the following seals: HNBR
Allowed temperature
range
Viscosity index sugge-
Kinematic viscosity
sted (°C)
suggested
VG (cSt = mm
Optimale kinematic viscosity
Max kinematic viscosity suggested at start-up
Viscosity index suggested
Working pressure
Contamination class NAS 1638
Contamination class ISO 4406-1999
To be optained with fi lter βx >75
according ISO 16889
N.B .: our Technical Service is at your complete disposal for any further information.
9700265012 AB 06/06/2023
Start-up and mounting guide for variable
displacement pumps
PPV
Filter
Outlet line
Optional drain
port
Ø SUCTION HOSE [mm]
Speed
800
1000 1200 1400 1600 1800 2000 2200
50
50
60
63
HYDRAULIC FLUID
-25 +80 °C
< -40
-40÷10
2
/s)
16
FILTRATION
(bar)
ΔP<140
140<ΔP<210
9
20/18/15
60
63
76
10÷35
> 35
22
32
46
VG= 10 cSt ÷ 100 cSt
Please full fi ll at least 80% capacity volume before pump
start-up
VG= 750 cSt
VI > 100
ΔP>210
8
7
19/17/14
18/16/13
10 μm
5
60-90-110-130 series
Main drain port with drain hose (min diameter G 1/2)
We recommend G 3/4 diameter hose when length
line ≥ 3 m.
PS: to avoid emptying the pump casing, always
connect the drain hose below the minimum oil level.
Oil tank
Breakwater
LS line (G 1/4)
We recommend G 3/8 dia-
meter hose when length line
≥ 3 m.
PUMP FILLING
PPV 60-90-110
total capacity
PPV 130 total
capacity
fi g. 2
800ml
900ml
99700265010
Publicidad
