Adjusting The Routing Depth; Dust Extraction; Working With The Machine; Machine Guidance Methods - Festool MFK 700 Manual De Instrucciones

– Attach a different clamping collet with lock-
ing nut to the spindle.
– Screw on the locking nut loosely. Do not
tighten the locking nut until a router bit is
inserted.

Adjusting the routing depth

1
8-1
3
– Unscrew the rotary knob [8-3] and the
clamp [8-1] ("large surface router table"
only).
– Turn the rotary wheel [8-2] to set the router
table to the required routing depth.
– Tighten the rotary knob [8-3] and the clamp
[8-1] ("large surface router table" only).

Dust extraction

Breathing in dust can dam-
age the respiratory passage! Always con-
nect the machine to a dust extractor. When
performing work that generates dust, always
wear a dust mask.
Extraction hoods are supplied for both router
tables; a Festool extractor (extractor hose
with a diameter of 27 mm) can be connected
to these extraction hoods.
The dust extractor (extractor hose with dia.
27 mm) can also be attached to the "large
surface router table" or the side stop depend-
ing on the application.
3
2
2
1
8-2
with both hands during working.
in such a manner that it cannot move
while being routed.
Guide the machine along the workpiece at
a steady rate of advance.
1
8-3

Machine guidance methods

8-2
a) Routing with side stop
The side stop is positioned parallel to the
workpiece edge.
The side stop can only be fi tted to the "large
surface router table" without a fi tted extrac-
tion hood.
3
8-3
9-5
– Insert the fi ne adjuster [9-3] into the side
stop.
– Secure both guide rods [9-5] with the two
rotary knobs [9-2] on the side stop.
– Insert the side stop into the grooves on the
router table to the required distance and
secure the guide rods by turning the rotary
knob [9-1].
Rough adjustment
– Loosen the screws [9-2] and [9-4] and slide
the side stop.
– Tighten the screws.
Fine adjustment
– Loosen the screws [9-2] and turn the green
wheel on the fi ne adjuster [9-3].
The distance between each line on the ro-
tary wheel is 0.1 mm - one full turn of the
ring represents 1 mm.
– Tighten the screws [9-2].
Working with
the machine
Always hold the machine
Always secure the workpiece
9-3 9-4
9-2
11
9-1