Chicco BI-SEAT Manual De Instrucciones página 69

correctly on the waist of the child.
f ) If used in a vehicle equipped with rear vehicle seat belts with in-
tegrated air bags (inflatable seat belts), the interplay between the
inflatable portion of the seat belt and this child restraint system
could cause serious injury or death. When using the car seat in
vehicles equipped with rear vehicle seat belts with integrated air
bags (inflatable seat belts), follow the car manufacturer's instruc-
tion manual.
g) Make sure that the buckle of the car's three-point belt is not too
far up. Otherwise, try to install the car seat on a different seat in
the vehicle. In some cases the vehicle seat belt buckle may be
too long and may exceed the expected height above the bot-
tom of the car seat (Fig. 55A-55B). In this case the seat must not
be fixed on that seat but must be installed on another seat on
which there is no problem. For more information, contact your
car manufacturer.
HOW TO CLEAN THE FABRIC COVER
The child car seat's fabric cover can be removed and washed by hand
or in a washing machine at 30°C, while the reducer cushion can only
be washed by hand. Please refer to the cleaning instructions on the
fabric label, which illustrates the following washing symbols:
Wash by hand
° C
Machine washable at 30°C.
30° C
Do not bleach
30° C
Do not tumble dry
Do not iron
Do not dry clean
Never use abrasive detergents or solvents. Do not dry the fabric cover
within a dryer, let it dry without squeezing it.
The fabric cover must only be replaced with another cover approved
by the manufacturer, since it is an integral part of the child car seat
and, therefore, one of its safety elements.
WARNING! To ensure the safety of the child car seat, never use it
without its fabric cover.
To remove the fabric cover follow the instructions below:
Cover
• Unfasten the car seat harnesses;
• Remove the shoulder straps;
• Use the buttons to unfasten the central flap of the cover;
• Remove the elastic bands located under the sitting area of the car seat;
• Pull the cover off.
Headrest
• Raise the flap located at the base of the headrest;
• Remove the elastic bands on the base of the headrest;
• Pull off the headrest.
HOW TO CLEAN THE PLASTIC AND METAL PARTS
Clean the plastic and coated metal parts with a damp cloth only. Never
use abrasive detergents or solvents.
The moving parts of the child car seat must not be lubricated.
69