BGS technic 70956 Manual De Instrucciones página 6

TIMING BELT IN SERVICE
•
On an in-service belt the tester (9) should show a reading between the upper and lower
grooves.
•
When the reading is at, or below, the lower edge of the lower groove the belt should be
replaced.
•
Check the manufacturers recommended belt change intervals.
CHECKING THE TENSION TESTER
Regularly check that the tester is reading correctly, as follows:
1. Fit the calibration button (7) to the plunger.
2. Apply the tester to the test plate (2), ensuring that the calibration button (7) sits in the central
depression in the plate (2).
3. The tester reading should be to the bottom edge of the lower groove.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed