Jimmy BD7 Pro Manual Del Usuario página 8

the other hand. (Figures 2, 3)
HEPA filter cleaning
Turn HEPA bottom cover clockwise; Take out
the HEPA assembly downward, tap the HEPA
assembly downward to clean the dust, or use
a brush to clean the dust and other debris on
the HEPA assembly. After cleaning the dust cup
and HEPA assembly, put the HEPA into the filter
assembly and then rotate it anticlockwise to fix
it. After the "click" sound is heard when rotating,
and the HEPA is assembled in place without
loosening.(Figures 4, 5)
Note:
1. Do not miss HEPA filter!
2. If too much dust is accumulated in the dust cup, clean
the dust cup and filter assembly with water, and wipe
them with dry cloth. Pay attention that HEPA filter need
to be washed as less as possible. Clean the dust and
foreign matters on HEPA filter by tapping, and ensure
that the dust cup and filter assembly are completely dry
before installation.
Brushroll cleaning and assembly
Note:
When cleaning the brushroll, be sure to disconnect the power supply to prevent the brushroll from starting by
mistake and cause human injury.
Turn off the machine, push the brushroll cover latch. Turn it from the closed state to the open
state, and then remove brushroll cover and take out brushroll. Clean brushroll with cleaning
brush. (Fig.6) After cleaning the brushroll, install the brushroll and brushroll cover back to
mainbody in turn, and lock the brushroll latch.
Dust sensor cleaning
Dust sensor is installed inside of air inlet. Use mini brush to clean inner wall of air inlet to avoid
too much dust accumulating on dust sensor and cause abnormal display of dust level.(Figures 7)
Maintenance and Storage
Please clean dust cup and filter after each use for further use. It is recommended to replace a
filter after 30-50 hours of working time(depending on specific situation) for better use.
Any paper, lead glass, plastic will greatly affect the effect of UV light. Please wipe and clean the
UV tube regularly for better use.
Do Not touch the UV tube as dirt will affect UV light effect.
6
2
Bottom cover
release button
4
6
Brushroll
Brushroll cover
3
Filer
assembly
5
HEPA
filter
7
Air inlet