Oregon Scientific EW92 Manual De Usuario página 6

4. Slide "°C/°F" switch to select between Celsius
and Fahrenheit.
5. Replace the battery door.
6. Press "+/CHANNEL" key to select the desired
channel.
Main unit is searching for the sensor(s)
(the icon will be flashing)
The sensor(s) cannot be found
Sensor 1 has been found
(the icon will be displayed,
but won't flash)
and "--"
The sensor(s) cannot be found after
(Outdoor
operating the main unit for 60 minutes
temperature
Area)
Note When the sensor signal is received, the icon
" " will be displayed on the LCD.
OPERATING THE SENSOR
1. Remove the battery door and slide
"CHANNEL" switch to synchronize the channel
with receiver.
2. Insert 2 new AAA size batteries as per the
polarity information marked on the battery
compartment.
3. Press "RESET" key to restart the clock.
4. Replace the battery door.
Note
The transmission range may vary depending on
many factors. You may need to experiment with
various locations to get the best results.
Standard Alkaline batteries contain significant
amounts of water. Because of this they will freeze
in low temperatures of approximately -12°C (10°F).
Disposable Lithium batteries have a much lower
threshold for temperature with an estimated
freezing range of below -30°C (-22°F).
Wireless ranges can be impacted by a variety of
factors such as extremely cold temperatures.
Extreme cold may temporarily reduce the effective
range between the sensor and the base station. If
the unit's performance fails due to low temperature,
the unit will resume proper functioning as the
temperature rises to within the normal temperature
range (i.e. no permanent damage will occur to the
unit due to low temperatures).
5