Publicidad
Idiomas disponibles
Idiomas disponibles
EN
INFORMATION
8. TROUBLE SHOOTING
You can solve many common problems easily, saving you the cost of a possible service call.
Try the suggestions below to see if you can solve the problem before calling the service centre.
Problem
Possible cause
The heater does not operate,
The plug is loose, bad connection
even when it is plugged in
and the switch, thermostat
No power in socket outlet
are switched on.
The input voltage is too high or too low
The heating element glowing
The air inlet grill is blocked
The switch was not
put at heating setting
The thermostat operated
The appliance didn't heat up,
or only ventilator worked
The self-resetting cut-out operated
Abnormal noise
The appliance is not stands upright
Disposal Environmental Protection
Waste electrical production should not be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.
Treatment
Pull out the plug, check the connection of the plug
and socket. Then connect again.
Insert the plug in a proper socket
Use power supply according to
the rating on the label
Keep the heater far way from articles like curtain,
plastic bag, paper and other things which can cover
the inlet or can be easily cover on the air inlet
Turn the switch to heat setting
Turn the thermostat and listen if there is open/close
voice. If there is no click and the thermostat is not
damaged, the heater will automatic switch on when
the appliance
cooled down
Turn the heater off and inspect the blockage of inlet
or outlet. Disconnect the plug and wait at least 10
minutes for the protection system to reset before
attempting to restart the heater.
Put the heater on a level surface
Publicidad
