Descargar Imprimir esta página

ELECTROTEK ET-EH1206 Instruciones De Montaje Y Uso página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

COMPONENTS OF THE HEATER.
BEFORE USING.
1. Before use, remove all packing material and inspect the unit in case he had a blow or other
damage. If there was any hit, scratch or other damage go to the place where you purchased
it and ask to be replaced by another one.
2. Check that the place where you are going to install the heater is not underneath from an
electrical outlet and not near flammable materials such as curtains.
SECURITY SYSTEM.
This heater has an "anti-tilt" safety system that consists of: a small push button on the base of the
heater so that when the heater it turns over, it turns off automatically.
OPERATING INSTRUCTIONS.
1. The door of the room must be closed for greater efficiency.
2. Plug in the heater.
3. Press the ON / OFF button (red) to turn on the heater, the central tube will light up.
4. If you want more heat, turn on one more tube or turn on the 3 tubes.
5. Each tube on adds 400W.
6. One tube lit 400W, 2 tubes lit 800W and 3 tubes lit 1200W.
7. If you press the TURN button, the heater rotates from left to right and from right to left.
8. To turn off the heater, turn off the tubes individually and finally the central one.
IMPORTANT SECURITY INSTRUCTIONS.
-
Never leave the heater unattended while it is plugged in and switched on.
-
While it is in operation, never cover it. It can cause fires.

Publicidad

loading