Lenco DAR-251 Manual De Usuario página 10

•
When disconnecting the power cord from the wall outlet, grasp the plug; do not pull the cord in order to
avoid shock risks caused by damaging the cable.
Operation
Press the POWER button once to turn ON and hold the button to power OFF the unit.
Adjusting the volume
Rotate the Volume knob clockwise to increase the volume.
Rotate the Volume knob counter-clockwise to decrease the volume.
The display will show the volume setting.
Mute function
Pressing the MUTE button on remote control will mute the volume is muted. "Volume Muted" will appear
on the display. Press this button again to cancel the mute function.
Setting Time
Setting the clock and date
After the unit is plugged into a mains supply or after a power failure, the time and date on the LCD display
will blink. The unit should be in standby mode to set the clock.
1. Press TIME button, "Time setup" is displayed, press ENTER to confirm.
 
2. Press / to select "24H" or "12H", Press ENTER confirm, the hour digits on the display will blink.
 
3. Press / to set the hour, press ENTER confirm, the minutes digits on the display will blink.
 
4. Press / to set the minutes, press ENTER confirm, the Year digits on the display will blink
 
5. Press / to set the Year, press ENTER confirm, the Month digits on the display will blink.
 
6. Press / to set the Month, press ENTER confirm, the Day digits on the display will blink.
 
7. Press / to set the Day, press ENTER confirm. Press
Setting Alarm
Note: Check that the radio has the correct time and date before you set an alarm.
This unit may be used as an alarm clock. The CD/USB device or DAB/FM radio/Buzzer is activated to play at a
preset time.
1. Press POWER to switch the unit to standby mode.
2. Make sure that you have set the clock correctly.
3. Press the ALARM button to set alarm 1; press ALARM button twice to set alarm 2
4. "Alarm 1 (or 2) Setup" is displayed. Press ENTER button to select.
5. "Alarm 1 (or 2) Setup On time" is displayed and the hour digits for the alarm will flash.
 
6. Press / repeatedly to set hour. Press ENTER to confirm.
 
7. Press / to set minute, Press ENTER to confirm.
 
8. Press / select the Alarm volume from 03 to 30. Press ENTER to confirm.
 
9. Press / to scroll to choose OFF/USB/CD/FM/DAB/BUZZER. Press ENTER to confirm.
 
10. Press / to choose the duration for the alarm. You can choose from 10 to 60 minutes. Press the
ENTER button to confirm. Use
11. The display will show the current time and Alarm 1 (or Alarm 2 or at the same time)
Warning:
- When alarm is set to DAB mode and there is no DAB signal, the alarm clock is silent.
When alarm source CD is selected and there is no CD inserted, there will be no alarm sound
Note: Choose Alarm source OFF if the alarm shouldn't activate the next day
-
 
/ to select YES and press ENTER to save the alarm setting.
- EN 10 -
 
/ the select save "YES/NO"