ESAB EM 215ic Instrucciones De Uso página 18

4 INSTALLATION
4.2 Lifting instructions
The power source can be lifted using any of the handles.
Secure the equipment - particularly if the ground is
uneven or sloping.
4.3 Electrical supply
The supply voltage should be 230 V AC ±10% or 120 V ±10%. Too low supply voltage may
cause poor welding performance. Too high of welding supply voltage will cause components
to overheat and possibly fail. Contact the local electric utility for information about the type of
electrical service available, how proper connections should be made, and inspection
required.
The Welding power source must be:
• Correctly installed, if necessary, by a qualified electrician.
• Correctly grounded (electrically) in accordance with local regulations.
• Connected to the correct size power point and fuse as indicated in table below.
WARNING!
Do not connect an input (WHITE or BLACK) conductor to the ground terminal.
Do not connect the ground (GREEN) conductor to an input line terminal.
NOTE!
Use the welding power source in accordance with the relevant national
regulations.
CAUTION!
Disconnect input power and secure employing 'Lock-out' / 'Tagging' procedures.
Ensure input power line disconnect switch is locked (lock-out/Tagging) in the
'Open' position BEFORE removing input power fuses. Connection/Disconnect
should be carried out by competent persons.
0463 407 001 - 18 - © ESAB AB 2017