Laurus LEH8 Manual De Usuario página 138

Installation of the Hotplate Hob
• Place the hob in the cut out. Mark the
location of the hob on the cooktop.
Marker
Hob
• Remove the hob. Place the gasket on
the line you marked. Make sure that the
line centres the gasket. Ensure that the
junctions overlap at the corners and no
gap is left along the sealing material.
Gasket
Line
you
marked
• Insert the appliance into the aperture
and fix in position using the brackets
(A) and screws (B). Adjust the position
of the brackets depending on the
thickness of the worktop and tighten the
A1
C1
D1
G1
H2
J2
Worktop
EN - 10
B1
E1
F1
F2
A2
G2
E2
D2
screws evenly. Carefully trim away any
excess sealing material (C) from around
the appliance.
C
Hob
A
B
Installation of the Vitroceramic Hob
• Apply the supplied one-sided self-
adhesive sealing tape all the way
around the lower edge of the cooktop.
Do not stretch it.
B2
C2
C2
C
Hob
t<25 mm
A
B
t>25 mm