Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO INSTALL THIS UNIT WITH POWER SUPPLY WIRE:
1.
Drill to 6 mm diameter holes according to
measures shown in picture and insert the
wall anchors.
2.
Fix the unit to the wall with the two
supplied screws. Once the unit is fixed,
insert the screw covers.
3.
Connect with power supply and move
power switch to "ON" position.
HOW TO INSTALL THIS UNIT WITHOUT POWER SUPPLY WIRE
1.
Follow the first step of above method.
2.
Loosen the screws of the cover to be able to open unit
and remove power supply wire.
3.
Open the wire hole located on the rear cover. Pull the wall
power supply wire through the hole.
4.
Connect the wall power supply wire and screw again the
cover so the unit is totally closed.
5.
Fix the unit to the wall with the screws after
checking that there is no mistake.
6.
Turn on general power and move power switch to "ON"
position.
HOW TO INSTALL IN DRAWER:
1.
Drill two holes of 4 diameter and the distance
between the two hole is 80 mm.
2.
Fix the base of this unit on bottom board of
drawer with the screws as per picture 5.
Screws
Picture 4
Picture 2
Picture 3
3.
Turn on general power and move power
switch to "ON" position.
Screws
Picture 5
Publicidad
