MPM MRK-17 Manual De Instrucciones página 22

EN
CHOPPING KNIFE ASSEMBLY
Place the container (19) on a dry and firm surface. Remove the lid from the container (19).
Then put the cutting knife (20) on the pin in the centre of the container bottom and close
the container so that the tip of the cutting knife (20) fits into the lid. Make sure every part
is correctly fixed and replace the blender housing (1) on the mounting socket in the cover.
Insert the plug into the power outlet.
In order to start the appliance press and hold down the switch (4) or (5).
ASSEMBLY OF CUTTING DISCS
Place the container (11) on a dry and firm surface. Remove the lid (13) from the con-
tainer (11) by pressing the lock release button (12) on the handle (11) and turn the lid
home, counter-clockwise (fig 2). Next put the discs pin (18) on the bolt in the cen-
tre of the container bottom, place one of the discs (16, 17) on the pin (18) and close
the container in such a way that the tip of the discs (16) (17) fits into the lid (13). Pay
attention to the marks on the container lid and handle (fig. 2). Follow the steps of fixing
the lid in the ASSEMBLY OF THE DICING ATTACHMENT section.
ASSEMBLY OF THE DOUGH HOOK
Place the container (11) on a dry and firm surface.
Remove the lid (13) from the container (11) by pushing the lock release button (12) and
turn the lid home, counter-clockwise (fig. 2).
Next put the dough hook (23) on the bolt in the centre of the container bottom and close
the container in such a way that the tip of the hook fits into the lid. Pay attention to the
marks on the container lid and handle (fig. 2). Follow the steps of fixing the lid in the AS-
SEMBLY OF THE DICING ATTACHMENT section.
ASSEMBLY OF THE WHISKING ATTACHMENT FOR WHIPPING EGGS, LIGHT CREAM AND
SAUCES
On the blender cover (1) mount the whisking attachment (21). Whisking attachment (21)
gets blocked the moment it is pushed into the blender housing. In order to detach the
whisking attachment (21), push the lock release (3) and pull it out.
POWER CONTROL KNOB
Blender has smooth power control by means of knobs (6). This function helps
to adjust the engine speed to the particular application. By turning the knob (6)
clockwise the power is increased; by turning it counter-clockwise the power is decreased.
TURBO FUNCTION
TURBO function (5) is used for temporary work at the highest speed. Pulse function –
only after pressing the (5) button . Power of the TURBO function is equal to the highest
value available by means of the control knob (6).
After pressing the TURBO button the appliance starts working at its highest speed/power.
This function can be used only for up to 30 sec. After this time turn off the appliance and
wait until it cools down.
ATTENTION! Before pouring out the content of the container wait until the knife stops rotating.
22