Publicidad
Idiomas disponibles
Idiomas disponibles
When the temperature in the room reaches the desired value (you can check the
temperature by means of a thermometer) leave the control handle in this position.
If the temperature does not suit you change the position of the control handle. This
temperature will be automatically maintained in the room later on.
5.2 Operation in the model of the room protection from freezing.
This mode is used to keep the temperature at approximately 7°C in the room when you are
absent from the house for a prolonged period (i.e. more than 24 hours).
Set the switch key to position "I" (keys of the power regulator to position "I"+"II"). Set the
thermostat handle to position. The convector nice automatically maintain the temperature in
the room at the plus level (5...7)°C, this protects the room from freezing.
5.3 Disconnection of the connector from the mains. Set the switches keys to the switched off
position "0", set the thermostat handle to the position with the designation and disconnect
the power cord plug from the mains socket.
5.4 Recommendations for use:
- there is no point in setting the unit to this maximum, the room temperature will not rise any
faster;
- When you air the room, disconnect the convector by putting the switch to "0".
- If you leave for several hours, remember to reduce the temperature.
Absence for:
- less than 2 hours, do not touch the controls.
- 2 to 24 hours, lower the thermostat handle by two graduations or set the one of switches
to "0" position.
- more than 24 hours or in the summer, set the thermostat handle to position (Frost
Free mode)..
- If you have several units in a room, let them operate simultaneously.
This will give you a more uniform temperature without increasing electricity consumption.
6 MAINTENANCE
To maintain performances of your unit, you should clean the upper and lower grilles of the
unit about twice a year using a vacuum cleaner or a brush.
Dirt may collect on the grille of the unit if the atmosphere is polluted. This phenomenon is
due to the poor quality of the ambient air. In this case, it is recommended to check that the
room is well ventilated (ventilation, air inlet, etc.), and that the air is clean. The unit will not be
replaced under the guarantee because of this type of dirt.
The unit casing should be cleaned with a damp cloth, never use abrasive products.
WARRANTY CONDITIONS
This guarantee is applicable for 2 years from the date of original purchase and shall be valid
for no more than 30 months from the date of manufacture.
The warranty covers exchange or supply of parts found to be faulty, excluding any damages
and interest payments.
This guarantee excludes damage by neglect, shipping or accident and any damage due to
incorrect installation, use for purposes other than those intended or failure to observe the
instructions given.
16
Publicidad
