Publicidad
Idiomas disponibles
Idiomas disponibles
EN
4. installation
4.1 Welder's Placement
• The dust, acid and erosible dirt in the air at the job site can not exceed the amount required by the norm.
• The welder must be installed in the place where it can not be exposed to sun and rain. Also it must be stored in less humid place
with the temperature range at -10~40°C.
• There should be 50 cm space about for the welding machine to have good ventilation.
• Apparatus to exclude wind and smoke should be equipped if the inside aeration is not sound.
4
1
2
3
4.2 Connection between Welder and Power Source
(See the Input Connection Sketch)
Connect the power source cable at the back board of the welder into the single phase
230 voltage power network with breaker.
5
6
7
8
8
1. Gas flowmeter
2. CO2
3. Gas pipe
4. Power input cable
5. Torch
6. Torch switch
7. Grounding cable
8. Work piece
INPUT 220-240V
MIG Back Pannel Sketch
Publicidad
