Memco C100 SM4 Guia De Instalacion página 6

Full Programming Options
Full Menu Structure
Quickstart >
Tel. Numbers >
Alarm no.1
Alarm no.2
Alarm no.3
Alarm no.4
Tech.no.
Background no.
Call attempts
Settings >
ID Code
Volume
System Config >
HW Monitoring >
Delays >
COP delay
AS delay
Tech IP delay
Hangup delay
Answer delay
Redial del.
VAD timeout
Messages >
Location
Reassurance
Guidance
Time/Date >
Time
Date
Advanced >
Passcode
Network ID
Next EN81 call
PBX Frequency
Language
Relay mode >
Relay override>
GMT Offset
Templates
Load Template
Save Template
Del. Template
Menu Sections explained...
Settings
ID Code
If using Memco GlobalNet to monitor the C100 enter the following:
[3 digit customer number][Unit ID code]
Volume
Press the up and down arrows to adjust the volume, and press
confirm.
System Config
Sets how the system will operate. Select / deselect which modes of
operation are required in the system using the
explanation of each option:
System Config
>

key. See below for a full
Multi-dial Sets the unit to call each of the
programmed alarm numbers one after
the other.
EN81-28 Mode Prevents the unit from accepting
incoming calls when not in an alarm
state and requires a passcode to enter
remote programming.
Consec. dial Changes the dialling sequence; all
call attempts to the first number are
completed before unit attempts to call
the second number and so on.
Alt. dial tone Allows system to work with an
intermittent dial tone.
Verbal c/down Units gives a verbal countdown until
the emergency call is placed.
Passcode?
Require a passcode to be entered
before accessing the 'System Config'
menu.
EOA pictogram
Sets the system to keep the alarm
pictogram lit whilst the unit is in an
alarm state.
Alarm tone Sets the unit to emit a tone from the
internal speaker when the alarm push
is pressed.
Hotline Use if setting as a hotline. A hotline
is where the C100 will automatically
connect to another extension within
the building telephone exchange.
Auto Location When an operator answers an alarm
call, the C100 will automatically play
the location message.
NOTE: when programming in the alarm
numbers 'UNGUIDED' protocol must
be selected (see section on Alarm
Numbers for more detail).
Avoid Silence During an alarm call the C100 will not
mute its speaker, unless the operator
presses the '2' key on their handset.

to