Publicidad
Idiomas disponibles
Idiomas disponibles
C
Raise temperature of 1 degree Celsius or Fahrenheit.
Display shows upper zone temperature at its setting.
D
E
Temperature display in Celsius.
F
Temperature display in Fahrenheit.
Display shows lower zone temperature at its setting.
G
Compartment selecting switch (lower or upper one). Once the compartment has been
selected, it will show setting temperature as flash, 5 seconds later flash will stop and setting
H
temperature will be showing
Alarm cancel switch, press once to cancel the alarm. Press and hold 5 seconds to change
I
Celsius or Fahrenheit.
J
Light ON/OFF switch, turn on and turn off the light.
Temperature selection
The wine cooler has two temperature zones. The temperature setting of upper zone is adjustable with the
range 5-12°C, which is ideal for storing sparkling and white wines. The temperature setting of lower zone
is adjustable with the range 12-20°C, which is ideal for storing white and red wines.
NOTE: both two zones temperature could be set at 12ºC, and it is workable at the same time. But for
optimal performance, once one zone is set at 12ºC, we suggest another setting for the other zone
with 3°C difference at minimum (example: 5°C upper and 8°C lower). Maximum temperature
difference between both compartments is 10°C. Always set cooler temperature in the upper
compartment and warmer temperature in the lower compartment (example: 5°C upper and 15°C
lower).
• To select the temperature zone, press (H) once, upper zone will flash, (H) key pressing again to
switch it to lower zone. Setting temperature could only be set under display flash status.
• You can touch key "+" (C) and key "-" (B) to set the internal temperature for the selected zone. The
degrees indicators will appear in the display window marked
• When the unit is plugged in for the first time, the LED readouts will show the original temperature set
previously. Touch the "+" (C) and "-" (B) mark once of each compartment to set the desired
temperature.
• The temperature will increase by 1°C or 1ºF if you touch the "+" (C) mark once, or the temperature will
decrease by 1°C or 1ºF if you touch the "-" (B) mark once.
When the surrounding temperature is 25℃ and the wine cooler has no bottle loaded, it will take
around 8 minutes to increase the wine cooler's temperature from 5℃ to 12℃. Under the same
circumstance, it will take around 12 minutes to decrease the wine cooler's temperature from 12℃ to
5℃. The less the temperature span is, the less time it will take. The setting temperature of upper
zone should be lower than the setting temperature of lower zone
Temperature display
Display show at its setting.
To view the actual temperature at any time, press buttons B and C on the control panel for 3 seconds. The
actual temperature will flash temporarily on the display. Then the set temperature will be displayed when
you stop pressing both buttons.
NOTE: when first used or after operating the wine cellar after a long period of inactivity, the inner
temperature will not immediately be the temperature setting on the display. Indeed, it is necessary to wait
a few hours for a temperature adjustment of the wine cellar in order to have a homogeneous temperature.
To avoid excessive condensation when the ambient temperature is above 28°C, do not lower the
temperature to below 7°C.
for upper zone and
45
for lower zone.
Publicidad
