Publicidad
Idiomas disponibles
Idiomas disponibles
STARTER 300C Portable Conductivity Meter
2.2
Installing the batteries
1)
Remove the battery cover screw using a coin or screwdriver and remove the battery cover
2)
Insert the batteries in the battery compartment as shown
3)
Replace the battery cover and tighten the battery cover screw
2.3
Installing the electrode clip
The electrode clip is an electrode holder that can be placed next to the display on either side of
the housing.
1)
Attach the clip by inserting the tabs into the recess.
2)
Slide the clip forward to lock in position. Slide the shaft of the conductivity electrode into the
clip from above.
2.4
Installing the IP54 cover
Use the small plastic tool as shown:
EN
5
-
Publicidad
