Worx WX425 Manual De Instrucciones página 10

How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well
maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately
managed.
WARNING: To be accurate, an estimation
of exposure level in the actual conditions
of use should also take account of all parts of the
operating cycle such as the times when the tool
is switched off and when it is running idle but not
actually doing the job. This may significantly reduce
the exposure level over the total working period.
Helping to minimise your vibration and noise
exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
10
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high
vibration tool use across a number of days.
ACCESSORIES
Blade
Parallel guide
Vacuum adapter (32mm&35mm)
Hex key
We recommend that you purchase your accessories
listed in the above list from the same store that sold
you the tool. Refer to the accessory packaging for
further details. Store personnel can assist you and
offer advice.
Circular saw
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE:
The machine is intended for lengthways and
crossways cutting of wood with straight cutting
lines as well as bevel angles to 45° while resting
firmly on the work piece.
1. DEPTH OF CUT ADJUSTMENT
(See Fig. A)
Lift the depth of cut lock lever and raise the saw
body away from the base plate. Set the depth of
cut with the scale and push the lever down to lock.
Always add 3mm to your depth of cut so that the
blade can cut through the material.
2. BASE PLATE ANGLE ADJUSTMENT (See Fig.
B1 & B2)
Lift the base plate bevel lock to loosen and rotate
the base plate to desired bevel angle with the scale
provided. Push the bevel lock down to clamp the
base plate position. Check the angle and ensure
that the base plate is firmly secured. The angle
markings on the base plate are accurate for most
general purposes but it is recommended to set the
angle with a protractor and make a test cut on other
material for accurate work. Do not use the depth of
cut scale when making bevel cuts due to possible
inaccuracy.
USING THE CIRCULAR SAW
1. SAFETY ON/OFF SWITCH (See Fig. C)
1 Your switch is locked off to prevent accidental
1 starting. Depress the lock off button then the on/
2 off switch and release the lock off button. Your
1 switch is now on. To switch off, just release the on/
off switch. The blade may continue to rotate after
switching off. Wait until the machine comes to a
complete stop before setting down.
Note: Keep the dust adapter connected to dust
collecting device when using the tool.
2. PARALLEL GUIDE ADJUSTMENT
(See Fig. D1,D2)
It is used for making cuts parallel to a workpiece
edge at a chosen distance. Slide the parallel guide
arm through the fixture to achieve the required
EN