Fellowes Powershred 450M Manual De Instrucciones página 3

BASIC SHREDDING OPERATION
Continuous operation:
NOTE: Shredder runs briefly after each pass
to clear entry. Continuous operation beyond
10-minutes will trigger 45-minute cool down period.
ADVANCED PRODUCT FEATURES
SilentShred™ Technology
Shreds without noisy disruptions.
PRODUCT MAINTENANCE
OILING SHREDDER
machine may experience diminished sheet capacity, intrusive noise when
recommend you oil your shredder each time you empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1 2
*Apply oil across entry Press and hold forward
( ) 2-3 seconds
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
TROUBLESHOOTING
illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous operation and recovery
time for this shredder.
Remove Paper: When illuminated, press reverse (
LIMITED PRODUCT WARRANTY
defects in material and workmanship and provides service and support for 2 years from the date
of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to
be free from defects in material and workmanship for 5 years from the date of purchase by the
original consumer. If any part is found to be defective during the warranty period, your sole and
exclusive remedy will be repair or replacement, at Fellowes' option and expense, of the defective
usage standards, shredder operation using an improper power supply (other than listed on
label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any
Australia Residents Only:
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other
PAPER OR CD/CARD
1 2
Set to Auto-On ( )
Plug in and
turn ON (I)
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare
occasions the sensors may become blocked by paper dust causing the motor to run even if there
is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry)
TO CLEAN THE SENSORS
1
OFF ( ) and
unplug shredder
additional costs incurred by Fellowes to provide parts or services outside of the country where the
more details or to obtain service under this warranty, please contact us or your dealer.
3 3
or or
Feed paper straight into Hold CD/card at edge,
paper entry and release
feed into center of
entry and release
Auto Reverse
Stops and reverses paper if a
jam occurs.
2 3
Locate Auto-start Dip cotton swab in
infrared sensor rubbing alcohol
.
4
away any contamination
from the paper sensors
3