Ingersoll Rand SCHLAGE BE469NX Guia Del Usuario página 5

locKING aND UNlocKING
L If you make a mistake while entering a User Code, press the Outside Schlage Button and
then start again.
locking from the outside
1. Press the Outside Schlage Button.
2. The lock will lock. The green check mark will light once.
L If the bolt cannot fully extend, the red X will light and a
tone will sound. The door may remain unlocked!
L If the Lock & Leave feature is disabled, a valid User Code must be
entered to lock the door. See enable/Disable lock & leave on
page 7.
locking from the Inside
Rotate the Inside Thumbturn.
L The Inside Schlage Button will not lock the deadbolt. It is used to
program and control the alarm. See Programming the alarm on
page 8.
Unlocking from the outside
1. Press the Outside Schlage Button.
2. Enter a valid User Code.
3. The green success check mark will flash twice and one beep will
sound. The deadbolt will unlock.
L If the red error X lights, the User Code was not valid.
Unlocking from the Inside
Rotate the Inside Thumbturn.
L The Inside Schlage Button will not unlock the deadbolt. It is used
to program and control the alarm. See Programming the alarm
on page 8.
cleaNING THe locK
In order to properly clean the touchscreen from build-up of dirt, oils, or other contaminates;
you should use a mild dish soap with warm water and follow the general rules below:
• Do rinse the touchscreen with warm water prior to cleaning process.
• Do follow the application of soap with a damp, lukewarm cloth
• Don't use abrasives, high alkaline cleaners, or gasoline
• Don't leave cleaners on touchscreen for long periods, wash immediately.
• Don't apply cleaners in direct sunlight or at elevated temperatures.
• Don't use scrapers, squeegees or razors.
The bolt itself can be cleaned, using a mild dish soap and warm water. This can help improve
decreased performance.
5