SUHNER ABRASIVE LVC 4 Documentación Técnica página 14

1. n
1.1 g
enerAl notes on sAfety
This operation manual is applicable for the machine LVC
4.
The machine may only be handled by personnel
who are qualified.
1.2 u
se of the mAchine for PurPoses for
which it is intended
The machine is designed for grinding, matting, structur-
ing, brushing, polishing and smoothing of metal, wood,
plastic and the like.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion of conformity
Otto Suhner GmbH, Trottäcker 50, D-79701 Bad Säck-
ingen, hereby declares under sole responsibility that
the product with the serial or batch no. (see reverse
side) complies with the requirements under the Directive
2006/42/EG. Applied standards: EN ISO 12100, EN ISO
11148. Document Agent: M. Voyame. D-Bad Säckingen,
04/2018. M. Voyame/Division manager
2. c
2.1 P
rior to tAKing the mAchine into serVice
Use oiled compressed air (see also air quality un-
der section 2.3).
Observe national regulations.
2.2 t
AKing the mAchine into serVice
2.2.1 t
urn on
Tilt lock forward and press lever on plastic sleeve.
14
S
oteS on afety
ommISSIonIng
2.2.2 t
urn off
Releasing the lever switches the machine OFF.
2.3 r
Ating dAtA
Pressure
Power output
Air consumption full load
Air consumption at idling
Setting oiler idle
No load speed
Sound pressure level ISO 15744
Vibration EN ISO 28927-3
Air quality ISO 8573-1
Lenght
Weight hand tool
2.4 o
PerAting conditions
Temperature range during operation: 0 to +40°C
Relative air humidity: 95% at +10°C not condensed
3. h
andlIng
3.1 t
ools
Use only clean tools!
3.1.1 c /
hAnging fitting the tool
Hold spindle by wrench flats with 17 mm open end wrench
and screw the tool. Perform a trial run a minimum over a
period of 30 seconds without load.
3.2 w
orKing instructions
On failure of the compressed air release the valve lever!
To achieve an optimum grinding result, move grinding
wheel uniformly back and forth with light pressure. Exces-
sive pressure lessens the working capability of the ma-
chine, as well as the life of the grinding wheel.
max. 6.3bar
320W
3
0.65 m /min
3
0.22 m /min
1-2 drops/min
-1
4'000 min
70.8dB(A), K=3dB(A)
2.3m/s2, K=1.5m/s2
3/4/4
354mm
0.900kg
/o
peratIon