RCA RCR311S Manual Del Usuario página 5

RCR311S_NA_IB_REVB_K4.qxd
3. If you are programming the remote to control your TV,
satellite receiver or cable box, go directly to step 5.
4. To program the remote to control a VCR or DVD. The
VCR•DVD key can control only one component, either your
VCR or your DVD. To program your remote to control either
your DVD or your VCR, you must first put the remote in
the proper programming mode. Follow these directions
before proceeding to step 5.
• •
VCR DVD ON OFF
•
VCR DVD
•
VCR DVD ON•OFF
(BLINK)
•
VCR DVD
5. Press and hold the component key
•
TV
SAT CBL
ON•OFF
(BLINK)
6. While holding the component key
•
ON OFF
7. After holding both keys down for
8. Release both keys. The illuminated
9. Refer to the Brand Codes in the
ON•OFF
(BLINK)
! TIP:
of each key, be sure to keep the remote
pointed at the IR sensor of the
component you are currently
programming the remote to control.
10. Press and release the ON•OFF key
ON•OFF
ON•OFF
(BLINK)
7/27/04 11:41 AM Page 5
a. Press and hold the VCR•DVD
key. The illuminated ON•OFF
key turns on.
b. While holding down the
VCR•DVD key, press and
release the number 2 key on the
keypad to control a VCR or the
number 3 key to control a DVD.
The illuminated ON•OFF key
turns off.
c. Release the VCR•DVD key. The
illuminated ON•OFF key blinks
four times and then turns off.
Your remote is now either in
VCR or DVD Programming
Mode, depending on which
you chose. Proceed to step 5.
(TV, VCR•DVD, SAT•CBL) you
wish to program. The illuminated
ON•OFF key turns on and
remains on.
down, press and hold the
ON•OFF key. The illuminated
ON•OFF key turns off.
three seconds, the illuminated
ON•OFF key turns back on.
ON•OFF key remains on.
enclosed Code Lists. Press and
release the appropriate brand code
key, using the number keys on the
keypad. The illuminated ON•OFF
key blinks once.
Throughout the programming
repeatedly until your component
turns off. Wait 4 seconds between
each key press. Each time you press
the ON•OFF key, the illuminated
ON•OFF key blinks, and the next
code is sent. The Brand Code
Search begins with the first code in
the chosen brand list for that
component and cycles through all
the codes for that brand. If your
component turns off, you have
found the correct code. (If it cycles
through and the illuminated
ON•OFF key blinks four times and
turns off, all codes in the chosen
brand lists have been searched. The
Brand Code Search mode is exited.)
5