Publicidad
Idiomas disponibles
Idiomas disponibles
Check / Connect Gun and Hose
1. If spray gun trigger depresses without pressing
trigger lock or if spray gun remains depressed when
released, replace spray gun immediately.
Trigger Lock
2. If high pressure hose is damaged, exposing inner
mesh, replace immediately.
3. Pull high pressure hose quick connect collar back,
slide onto spray gun and release. Tug on hose to
ensure it is secure.
4. Pull high pressure outlet quick connect collar back,
insert high pressure hose and release. Tug on hose to
ensure it is secure.
WARNING! The high pressure fluid could cut
through skin and its underlying tissues, resulting
in serious injury and possible amputation. Never
attach spray wand directly to high pressure hose.
Check Water Inlet Screen / Connect Garden Hose
1. Inspect inlet screen. Remove debris or replace if
damaged.
2. Run water through garden hose (not to exceed 50 ft
(15 m) to clean out debris, then connect to water inlet.
NOTICE There must be at least 10 ft (3 m) of
unrestricted garden hose between the pressure washer
inlet and any device, such as a vacuum breaker, to
prevent pump damage.
8
3. Turn on water, point spray gun in safe direction, press
4. Attach spray wand to spray gun. Tighten by hand.
Step 4: Spray Tips
1. Select desired spray tip:
2. Pull spray wand quick connect collar back, insert
Inlet Screen
trigger lock and depress trigger to purge pump system
of air.
Low Pressure
Black Soap
Use to apply
detergent
General Rinse
Yellow, 15°
Siding /
Patios Decks
Driveways /
Garage Floors
spray tip and release. Tug spray tip to ensure it is
secure.
Delicate Rinse
White, 40°
Green, 25°
Cars / Vans
/ Trucks /
Outdoor
Furniture
Maximum
Rinse
Red, 0°
Paint Removal
/ Oil Stains
/ Rust Removal
www.husqvarna.com/us
Publicidad
