Hilti BX 3-SCT Manual De Instrucciones Original página 15

Trouble or fault
Fastener driven at an angle.
10 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
12 Further information
For more information on operation,
qr.hilti.com/manual/?id=2338837
This link is also to be found at the end of the documentation, in the form of a QR code.
13 FCC statement (applicable in US) / IC statement (applicable in Canada)
The product complies with part 15 of the FCC Rules and RSS­210 of the IC.
Operation is subject to the following two conditions:
• This device shall cause no harmful interference.
• This device must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly approved by Hilti can restrict the user's right to operate the
device.
Notice d'utilisation originale
1 Indications relatives au mode d'emploi
1.1 À propos de ce mode d'emploi
• Avant de mettre l'appareil en marche, lire impérativement ce mode d'emploi.
préalablement requise pour assurer la sécurité du travail et un maniement sans perturbations.
*2338837*
Possible cause
Too much contact pressure ap-
plied through the grip to the fas-
tening tool.
Fastening tool was angled off the
driving axis when pressed against
the surface.
technology,
2338837
Action to be taken
▶ Apply less pressure to press
the fastening tool against the
surface.
▶ Press the fastening tool at right
angles against the surface, ap-
plying pressure to the gripping
surface on the back of the
fastening tool.
environment and recycling, follow this link:
C'est la condition
Français 11