TRENDnet TW100-BRM504 Guía De Instalación Rápida página 9

Troubleshooting
Q1: I typed http://192.168.0.1 in my Internet Browser's Address Bar, but an error
message says "The page cannot be displayed." How can I get into the
TW100-BRM504's web configuration page?
A1:
First, check your hardware settings again by following the instructions in Section 2.
Second, make sure the LAN and WLAN lights are lit. Third, make sure your TCP/IP settings
are set to Obtain an IP address automatically (see the steps below).
1. Go into the Control Panel and double-click
the Network Connections icon, right-click
the Local Area Connection icon and then
click Properties.
2. Click Internet Protocol (TCP/IP) and then
click Properties. Then click on Obtain an
IP address automatically.
Fourth, press on the factory reset button for 15 seconds.
Q2: The Modem does not auto-detect my DSL connection. What should I do?
A2:
First, verify that your DSL account is activated. Second, make sure all the cables are
properly connected (see Section 2). Third, in Section 3, select manual selection in the Setup
Wizard and configure the Modem based on information provided by your ISP.
7