Descargar Imprimir esta página

Polar G377 Manual De Instrucciones página 6

Frigoríficos / congeladores de mostrador de acero inoxidable

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 42
EN
Cleaning, Care & Maintenance
Defrost appliance at least every 3 months, more often if required.
Switch off and disconnect from the power supply before cleaning.
Clean the interior of the appliance as often as possible.
Do not use abrasive cleaning agents. These can leave harmful residues.
Clean the door seal with warm soapy water.
Always wipe dry after cleaning.
Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
Take care when cleaning the rear of the appliance. Sharp edges can cut.
Refrigerating tips:
Condensation and ice will form with frequent and prolonged opening of the doors.
Operating outside of the recommend temperature range and placing next to a heat source will also
increase the amount of ice and internal/external condensation. If external condensation occurs wipe
the surface down with a cloth.
Excessive ice will result in longer running times that will increase energy consumption and increase
the deterioration of components.
If the gasket or seal is damaged or deformed, energy consumption will increase. To restore efficiency,
replace gasket.
Stainless Steel Care
To maintain the stainless steel exterior of your Polar item, please consider the following information:
Never:
Use abrasive Scourers or scrubbing pads, etc.
Use Chlorinated or acidic detergents
Allow anything e.g. food, dirt, cleaning chemicals to remain on the surface for longer than necessary,
clean them off right away.
Allow the surface to remain wet.
Do:
Clean often.
Use soft Cloths or plastic Scourers.
Rub with the grain of the metal, rather than across it.
Use detergents and polish designed for cleaning Stainless Steel.
Ensure that the cleaning products are washed off fully and that the steel is left dry.
Condenser Cleaning
The condenser is part of the refrigeration
system. The condenser requires monthly
cleaning.
Always disconnect power supply before carrying
out Routine Maintenance.
Failure to clean the condenser will reduce the
performance and life of your Polar unit and may
invalidate your warranty.
The condenser is located behind the service
door on the right-hand side of the refrigeration
cabinet.
These models have a removable filter which can
be cleaned with a vacuum cleaner.
6
G377-G379_G596-G600_GD873-GD874_DL914-DL917_GL182-GL184_ML_A5_v7_20230504.indb 6
G377-G379_G596-G600_GD873-GD874_DL914-DL917_GL182-GL184_ML_A5_v7_20230504.indb 6
2023/5/4 15:07
2023/5/4 15:07

Publicidad

loading