Putting Into Service And Testing Operations - Vimar EIKON CO Stop 20422 Instrucciones De Uso

3. Putting into service and testing operations

• Provide power to the device: the three LEDs light up simultane-
ously for about 1 s and after a brief acoustic signal they turn off
and then come back on according to the code of the detector.
Then the detector warms up for about 1 min. During this time
the commands to the output relay and buzzer are inhibited: the
green and yellow LEDs flash simultaneously to mark this phase.
• Once the warm-up time is finished, the yellow LED
off while the green LED
detector is operating regularly.
• If there is an alarm the red LED
lets off a continuous noise. Once the alarm is over the device
returns to normal operating conditions
• If the device fails the green LED
constant mode, while the yellow LED
case it is necessary to contact an installer.
6 - ENGLISH
turns
starts flashing, indicating that the
stays on and the buzzer
shifts from flashing mode to
starts flashing. In this
Note
• do not expose the device to:
- fumes from solvents
- fumes from perfumes, bleach, ammonia etc.
- fumes from glue, paint, silicone
- gas different from that prescribed
• the detector is operating correctly when the green LED
flashing. If the green LED
the detector is no longer operating.
is constantly on or off it means that
is