Attaching a smartphone to the selfie stick
♦
Pull the clamps of the smartphone holder 2 open.
♦
Place the smartphone between the clamps of the smart-
phone holder 2 by pushing the upper clamp upwards
against the spring force. Check that your smartphone is
securely in place.
♦
Loosen the locking screw 3 and adjust the vertical tilt angle
of the smartphone. Fix the smartphone in the desired posi-
tion by re-tightening the locking screw 3.
♦
If necessary, attach the remote release 8 to the lower part of
the telescopic shaft 4 using the remote release holder r.
Taking selfies
♦
Release the lock of the telescopic shaft 4 by turning it
anticlockwise.
♦
Pull out the telescopic shaft 4 to the desired length. Turn the
individual elements of the telescopic shaft 4 clockwise to
lock them in place.
♦
If you want to unlock the telescope shaft 4 again, turn the
individual elements in the opposite direction (anticlockwise).
♦
Switch on the camera function on your smartphone.
♦
Press the
smartphone will take a picture. The operating LED 0 briefly
flashes blue once.
NOTE
►
If the
button q is not pressed for approx. 6 minutes, the
remote release 8 switches off automatically.
Using the mini tripod
♦
Screw the mini tripod 1 into the ¼ inch thread 7 on the
bottom of the handle 5.
♦
Always pull the legs of the mini tripod 1 fully apart for
maximal stability.
│
GB │ IE
■
10
button q on the remote release 8. Your
SSBS 3.0 A2