Casselin CLVA50 Manual página 19

3. TRANSPORT, PACKAGING AND STORAGE
3.1 Inspection after transport
Checking for damage and the completeness of the device must be carried out upon receipt of the package.
In the event of identification of transport damage, refuse or accept the delivered product only with reservations
*. A complaint detailing the defects observed must then be made. The perception of damage is only possible
in the event of a complaint formulated within the time limits, ie 24-48 hours maximum.
* written on the carrier's delivery papers or digital.
3.2 packaging
The packaging of the device must be kept in case of moving, or for a return to the after-sales service. The
inner and outer packaging must be completely removed before using the device. The standards in force in
your country concerning environmental protection must be observed before destroying the packaging.
3.3. Storage
WARNING
The device can be kept in stock, but only in its original, closed packaging.
Storage can be carried out in accordance with these conditions:
• Storage in a dry and non-humid place
• Sheltered from the sun
• Control of the stock greater than 2 months (general condition of the device and all the constituent elements)
• No material shaking
• Storage in closed room and not outside.
4. INSTALLATION AND USE
4.1 Safety instructions
ELECTRICAL HAZARD
Danger from electric current!
• No contact with heat sources should take place with the power cord.
• Cord should not hang over edge of table or counter.
• The device must be properly connected and comply with the regulations in force.
WARNING
In operation, the device can reach high temperatures. To avoid burns and accidents, do not use the device
in malfunction, and do not use non-original spare parts.
ELECTRICAL HAZARD
Danger from electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The appliance must be unpacked
and checked completely before connection by a professional.
4.2 Installation and use
WARNING
The set-up of the device installation and maintenance should only be carried out by professionals.
• Do not move or tilt the device during operation.
All manuals and user guides at all-guides.com
EN