BTI PROFILINE A-ST 18V Instrucciones De Manejo página 52

E N G L I S H
WARNING: NEVER use a light socket.
NEVER connect the live (L) or neutral (N)
wires to the earth pin marked E or
Using an Extension Cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger (see
technical data). The minimum conductor size is 1 mm
the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.
Assembly and Adjustment
WARNING: Prior to assembly and
adjustment, always remove the battery pack.
Always switch off the tool before inserting or
removing the battery pack.
WARNING: Use only BTI battery packs and
chargers.
Inserting and Removing the Battery Pack
from the Tool (fi g. A)
1. Insert the battery pack (11) into the grip until it
clicks in place.
2. To remove the battery pack, press the two battery
release buttons (12) simultaneously and pull the
pack out of the grip.
Fitting and Removing a Saw Blade (fi g. C)
The tool-free blade exchange system ensures quick
and easy changing of saw blades.
• Open the blade holder (6) by fully retracting the
blade latch (4).
• Insert the saw blade into the blade holder (6)
guiding the back of the blade into the groove of
the guide roller (7).
• Release the blade latch (4).
• To remove the saw blade, fully retract the blade
latch and pull the blade out of the holder.
SAW BLADES
Blade type
Fine-toothed cutting blade for smooth straight cuts
Coarse-toothed cutting
blade
Metal cutting blade
Flush cutting blade
Not available in all countries.
1)
.
A wide variety of dedicated saw blades is available as
an option.
WARNING: Always select your saw blade
with great care.
;
2
Setting the Bevel Angle (fi g. D)
The adjustable shoe (8) allows cutting of LH and RH
bevel angles up to 45°. The bevel scale has preset
positions at 0°, 15°, 30° and 45°.
• Release the shoe lever (10).
• Slide the shoe (8) toward the saw blade.
• Tilt the shoe and set the desired bevel angle using
the scale.
• Tighten the shoe lever.
Setting the Pendulum Stroke (fi g. A)
The adjustable pendulum stroke guarantees a perfect
cutting stroke for different materials.
• Slide the selector (9) to the desired position
referring to the table below. The selector can be
manipulated during operation.
Pos.
3
2
workpieces
1
Chipboard
0
workpieces
Setting the Sawdust Blower (fi g. A)
The sawdust blower conducts an adjustable stream
of air to the saw blade to keep the workpiece clear of
sawdust during operation.
• Set the sawdust blower using the lever (3).
– Low: For working with metals, when using
coolants and lubricants and for use with dust
extraction.
52
Applications
for fast straight cuts
for ferrous and non-ferrous
metals
for fi nishing off cuts up to
1)
a wall or edge.
Wood Metal Plastics
Fast cuts – PVC
Thick – Fibreglass
Acrylic
Plywood Aluminium
Non-ferrous
Thin Sheet metal
Fine cuts
–
–
–