Tare Function - Tanita KP-601 Manual De Instrucciones

CALIBRATING
Use the provided 100 g test weight.
1 2
Press the open Set the Gem cup.
button to open the
cover.
5 6
Press CAL.
When blinks,
place the test weight
gently onto the gem
cup.
WEIGHING
1 2
When the scale is on Place the object.
: Overload. The object being weighed exceeds the maximum capacity.
4
3 4
Turn the power on. The weighting unit
that was used when
the power was
turned off last time
will be displayed.
Default is g.
7 8
Calibration is Remove the test
complete. Calibration
weight.
is not complete when
not showing .
Make sure the stable
mark is displayed.
3 4
Remove it. Press OFF.

TARE FUNCTION

If TARE is pressed in the middle of weighing, zero (0) appears in the display enabling additional
weighing.
1 2
Place the object to When the stable
be measured on the mark is on, press
scale. TARE.
SWITCHING UNIT
When the weighing function is available, press the MODE button and the display switches in the
order below.
g → ct → oz → ozt → dwt → grain
COUNTING
1 2 3
When the scale Press and hold
is on MODE.
6 7 8
When stabilized, Press CAL. The number of
a stable mark is specimens are
displayed. displayed.
4 5
Press CAL. Place 10
specimens to be
weighed.
9 10
Place the number Remove the
of objects that you objects after
wish to count. measurement is
finished.
5