Duracraft NATURAL COOL MOISTURE DH-890 Serie Manual De Instrucciones página 5

S E T U P
NOTE: We recommend that the humidifier be disinfected prior to first use.
Please see CLEANING instructions.
• Select a firm, level, flat location — at least six inches (15 cm) from any wall for proper air
flow (Fig. 1).
• Place the humidifier on a water-resistant surface, as water can damage furniture and some
flooring. Duracraft
spillage.
F I L L I N G
Fig. 1
• Remove the water tank by grasping the handle and pulling straight up (Fig. 1).
• Lift up on the Motor Housing to remove and set aside (Fig. 2). Remove the Natural Cool
Moisture ® filter from the base before filling the unit with water. Soak in a sink full of cool
water to help reduce mineral build up and place back in the humidifier while wet. DO NOT
SQUEEZE OR WRING OUT THE NATURAL COOL MOISTURE
your filter repeat this step each time you fill your humidifier.
• Turn the water tank upside down so that the fill cap is facing up; unscrew the fill cap by
turning it counter-clockwise
• Fill the water tank with COOL tap water (Fig. 3). Distilled water is not necessary as the water
is filtered by the Natural Cool Moisture
damage the humidifier.
• Replace the fill cap by turning it clockwise
tank right-side up.
® will not accept responsibility for property damage caused by water
Fig. 2
6"
and set aside.
Lift
® filter. DO NOT USE HOT WATER. Doing so may
. DO NOT OVER TIGHTEN. Turn the water
Fig. 3
FILTER. To help extend the life of
®