Publicidad
Idiomas disponibles
Idiomas disponibles
- Make sure the ON/OFF switch is in the OFF posi-
tion.
- Connect the garden hose to the inlet fitting.
- Insert the adjustable spray nozzle into the gun ac-
cording to the assembly instructions in step #1.
- Connect the high-pressure hose to the high-pres-
sure outlet fitting according to the assembly instruc-
tions in step #2.
- Connect the high pressure hose to the gun accord-
ing to the assembly instructions in step #3.
- Connect the high-pressure hose to the indicated
detergent bottle according to the assembly instruc-
tions in step #4.
- Fully open the water supply valve.
- Before turning on the device, press the gun trigger
to release all residual air from the pump and hose.
- Turn on the high-pressure cleaner by turning the
ON/OFF switch to the ON position and press the trig-
ger. NOTE: The motor does not run continuously, but
only when the trigger is pressed.
WARNING - SPRAY HAZARD! The device starts
spraying when you press the trigger. When you turn
off the device after use, there will still be high pres-
sure in the hose and in the device. Point the gun in a
safe direction and release excess pressure. NEVER
direct the high-pressure water stream towards people
or animals.
Automatic on and off
The high-pressure cleaner is equipped with an auto-
matic switch. The pressure washer will only run when
the switch is in the ON position and the gun trigger is
pulled. When you release the trigger to stop spraying
water from the gun, motor high
the pressure washer will stop automatically. To reuse
the cleaner, simply press the trigger again. To stop
using the pressure washer, release the trigger and
turn the power switch to the OFF position. The device
should be completely switched off when not in use or
unattended.
Bleeding the gun
It is very important to bleed the gun before using the
pressure washer. You can find the installation instruc-
tions for the high-pressure cleaner in the "Installation
instructions" section. To bleed the gun, simply con-
nect a garden hose to a pressure washer and pull the
trigger BEFORE turning on the power. This will allow
air trapped inside the pressure washer and gun to be
released before using the equipment. Hold the trigger
for approximately one minute to release any excess
air from the device. During this operation, water will
flow through the gun under low pressure. See the
section titled "Operating Instructions" for more vent-
ing tips.
Pistol safety lock
This pressure washer is equipped with a safety lock
on the gun trigger. When the pressure washer is not
in use, use the safety lock to prevent the high-pres-
sure spray from being accidentally started.
Adjustable spray nozzle
The adjustable spray nozzle allows any variety of
spray patterns to be used from a full circle spray (Dia-
gram 1) to a straight stream spray (Diagram 2). When
using a pressure washer to clean wooden boards,
tiles, vehicles, etc., always start with a circular spray
and start spraying from a distance of at least 90 cm
to avoid damaging the surface of the material you are
cleaning. Always start by spraying a test area free of
people or objects.
- Warning: High pressure nozzles can be dangerous
if used incorrectly. The nozzle must not be directed at
persons, live electrical equipment or the equipment
itself.
- Do not point the nozzle at yourself or other people to
clean your clothes or shoes.
Detergent nozzle
The detergent nozzle allows you to use many forms
of liquid detergents on your work surface. Only fill the
tank with cleaning agent. Do not put any water in the
reservoir. The high-pressure cleaner will automati-
cally mix the water with the cleaning agent. When
you have finished applying the cleaner to the work
surface, attach the adjustable spray nozzle and use a
57
Publicidad
