Sennheiser Wireless RS 45 Instruciones Para El Uso página 8

Adjusting the volume
Set the volume of your sound source to a
medium value. With some devices, the volume
for the headphone output can be regulated
separately.
Use the V control on the right earpiece to
OLUME
adjust the headphones´ volume.
Adjusting the receiver channel
First switch on the transmitter (see section Where
to place the transmitter). Then switch on the
headphone receiver - as soon as the receiver is
switched on it automatically tunes itself to the first
strong signal found (normally the transmitter
frequency). If, for some reason, the selected
channel is not the correct one (eg: because of
interference or another nearby system), press the
T button on the earpiece and the auto-tune function will re-tune to the next
UNE
strong signal. Repeat this until you can hear the audio signal loud and clear. If you
decide to change the transmitter channel, the receiver search tuning must be re-
started by pressing the T
Changing the transmission channel
To avoid interference caused by the
simultaneous operation of several transmitters,
select a different channel on each transmitter.
Depending on the system variant, two or three
switchable transmission channels are available.
To select a channel, press the C
until the desired LED or LED combination lights
up:
LED 1
LED 2
LED 1 and 2
Complete freedom of movement
It is not necessary that transmitter and
headphone receiver are in a direct line of sight,
so you can move around freely in the home or
outside in the garden. One transmitter can be
used to transmit to several receivers on the
same frequency.
Additional headphones with the designation
HDR 45 are available from your specialist
dealer. Please make sure to choose
headphones with the same frequency range as
the transmitter you are using (see type plate on the bottom of the transmitter).
Wireless RS 45-8
button on the headphones again.
UNE
button
HANNEL
channel 1 active
channel 2 active
channel 3 active (except 863 MHz version).