Heco NEW PHALANX 302A Manual Del Usuario página 8

• Do not use any cleaning agents or chemical solvents when cleaning, as these could damage the
surface of the device.
• Repairs must always be conducted by qualified specialists, as you might otherwise be exposed
to dangerous high voltage levels or other hazards.
POSITIONING
The frequency range reproduced by the subwoofer cannot be pinpointed by the human ear. That's
why positioning generally doesn't present any problems. However, it is preferable to place the
speaker close to the front loudspeaker in front of the listening position. You should also make sure
that the distance from the sides and from the rear to items and walls is at least 20 centimetres as
otherwise bass reproduction may be impaired.
THE SUBWOOFER'S OPERATING ELEMENTS (FIG. 1)
Mains connection (11), mains-voltage switch (8)
The subwoofer is equipped with an integrated amplifier and needs to be connected to a mains
outlet by means of the supplied mains cable. The voltage selector has been set at the factory to 230
V for operation in Europe.
Warning: Connecting the subwoofer to a 230 V mains outlet while the voltage selector is set to 120 V will lead to
immediate destruction of the amplifier!
Operating mode switch (6), operating state LED (5), power switch (9)
Power switch ON
Operating Subwoofer is in permanent operation, the LED is
mode switch green.
ON
Favourable setting for the reproduction of
programmes with long quiet passages (this prevents
the subwoofer from switching off unintentionally).
Operating The automatic switching on/off is activated
mode AUTO (recommended setting).
The subwoofer switches on automatically when it
receives a signal from the receiver, the LED turns
green.
It automatically switches to standby after receiving
no signals for some minutes, the LED turns red.
Line inputs (7)
For connecting to level outputs on a receiver/amplifier (stereo mode), see Fig. 2.
For connecting to an AV receiver with low-level subwoofer output, see Fig. 3.
8
Power switch OFF
The subwoofer is
switched off, LED is off.
This is the setting for
when subwoofer isn't
used over long periods.