Publicidad
Idiomas disponibles
Idiomas disponibles
UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
MOUNTING THE SPEAKER
See back of the manual for detailed illustrations.
Step 1: Unscrew both bolts that secure the bracket to the speaker.
Step 2: Attach the bracket to a suitable surface.
Step 3: Screw both undone bolts back in, securing the speaker to the bracket.
Step 4: Pull off the left side rear cover to expose the connector terminal. Connect the speaker to the output of the amplifier
(Black = negative pole / Red = positive pole).
Make sure the audio system is turned off (and select N/C on rotary switch; Step 5) before making any connection.
Step 5: Pull of the right side rear cover to expose the rotary selection switch. Adjust the rotary switch to 70V/100V or 8Ω
position (for directly operating the speaker at a low-impedance amplifier output). When connecting several speakers, make sure
that all speakers have the same polarity and that the amplifier is not overloaded.
Connection examples
100V examples:
8Ohm examples:
3
Publicidad
