Publicidad
Idiomas disponibles
Idiomas disponibles
75 Series Installation
Diverter Cartridge Installation
2
A.
1
4
3
For Diverter Cartridge Installation:
Apply silicone lube to the o-ring (2) to make
the diverter sleeve (3) easier to install diverter
cartridge.
Rotate the diverter cartridge (1) so the pin is at
the bottom for proper installation.
Apply silicone lube to the o-rings (4) to make
the diverter sleeve (3) easier to install diverter
cartridge.
Align diverter sleeve so that the notches are in
the same position as the notches on rough-in
body (5).
Trim Installation
3
A1.
1
3
3
Escutcheon Installation
For finished wall thickness up to 1 1/8". Slide
o-ring (4) over cartridge and bonnet. Secure
the escutcheon (1) to the rough-in body (2)
using 4 screws (3) provided. Do not over tighten
escutcheon screws.
82666 Rev. G
5
2
2
4
B.
1
5
Diverter Bonnet Installation
Slide bonnet nut (1) over diverter sleeve (2) and
thread into rough-in body.
Hand tighten securely.
A2.
8
9
Slide trim sleeve (5) over valve cartridge (6) and
bonnet (7).
Place escutcheon cover (8) onto escutcheon and
hand tighten trim nut (9) provided onto diverter
sleeve until secure.
No t e : F o r t h i ck w al l i nst al l at i on, or der
installation kit RP90545 to support finished
wall thickness up to 2 1/8".
4
2
5
6
7
Publicidad
