BST PRO12DSP Manual De Uso página 4

4 • PRO12DSP / PRO15DSP
• Bluetooth
• 2 Combo inputs, one of which with LINE/MIC selector
• Input gain control
• XLR line output
• Separate volume controls on every input
• Two inserts for stand mounting: upright and tilted
• Slanted shape for tilt or stage monitor
Control Panel
1. USB port: Connect this port to the computer to adjust the DSP frequency response of the unit
2. Bluetooth button : Press to activate the Bluetooth function. If the item is connected to a Bluetooth
device, the blue LED doesn't flash. If it is not connected. the blue LED is flashing.
3. DSP knob: Press to toggle between graphic and edit mode. Rotate to change the parameter values.
4. Input A : Line A input signal interface
5. Volume control for input A and BT : from -ꝏ to middle is the normal range, from middle to max is the
CLIP range. Make sure not to the overload the speaker.
6. Mix output : connect this output to the signal input of another active speaker
7. Input B : audio signal for Line B / MIC input
8. Volume control for input B and MIC : from -ꝏ to middle is the normal range, from middle to max is the
CLIP range. Make sure not to the overload the speaker.
9. Switch for toggle between Line and Mic input
10. Power Switch : Switches the unit on / off
11. AC input : connect IEC power cable here to supply power to the unit
BLUETOOTH MODE
Press the BLUETOOTH button. The LED will flash. Activate the search function on your Bluetooth device and
select PRO-DSP in the list of found devices. Press again the BLUETOOTH button to disable Bluetooth.
DSP MODES & CONFIGURATION
The DSP wheel (3) and the LCD display allow the user to easily navigate through the different modes and
functions of the built-in DSP.
4 modes are already pre-programmed (Normal, Jazz, POP and Classic). In addition, there is a CUSTOM mode
which is a user mode and can be programmed according to the user's needs.
The Custom mode allows the user to adjust all the important parameters of the speaker.
The 4 pre-programmed modes can also be changed to adapt the speaker's sound to the customer's needs.
CAUTION: Changing these settings will directly affect the speaker's performance and in extreme cases may
even damage the speakers. It is not recommended to manipulate them without a minimum of knowledge.
Editable parameters of the DSP :
EQ ... : allows the adjustment of the parametric equalizer. There are 5 parametric bands. For each band you
can adjust the frequency, the Q parameter (bandwidth) and the gain.
HF : allows the adjustment of the frequency band and the gain of the high pass filter (tweeter)
LF : allows the adjustment of the frequency band and the gain of the low pass filter (woofer)
H Limiter - Allows you to adjust the high frequency limiter
L Limiter : allows the adjustment of the low frequency limiter