Publicidad
Idiomas disponibles
Idiomas disponibles
Care and Cleaning (continued)
□
Clean the pump rotor approximately once a month. A good indication that the rotor needs to be cleaned is if the water flow rate
drops. To clean the rotor and associated parts.
1.
Unplug the pump.
2.
Remove the pump from the water reservoir and disconnect the flexible hose from the pump outlet (1).
3.
Remove the filtering cover (2) and pressure-casing (3) from the front of the pump body.
4.
Clean the rotor (4) and housing (5) in clean water using cotton balls.
5.
Reassemble the pump, reconnect the flexible hose to the pump outlet (1), and place the pump back into the reservoir.
Troubleshooting
Problem
The pump will not run.
Specifications
MZZ20250DA PUMP
Model No.
Operating Voltage
Frequency
Current
Power consumption (Watts)
Delivery head
Delivery
Maximum submersion
3
2
Probable Cause
There is a faulty circuit breaker.
There is a faulty outlet.
There is not enough water in the fountain.
The flow control is low.
The pump is clogged.
The fountain is clogged.
The pump is air locked.
MZZ20250DA
120 V
60 HZ
0.04 A
2.5 W
2.3 ft. (0.7 m)
250L/h
66G/h
1
5
4
Solution
Check the circuit breaker.
Try another GFCI outlet.
Check the water level in the fountain.
Check the setting on the pump's flow control.
Check the pump discharge intake for dirt and
debris.
Check the fountain tubing for kinks and
obstructions.
Plug and unplug the pump several times.
7
Please contact 1-877-527-0313 for further assistance.
Publicidad
