Descargar Imprimir esta página

Craftsman 675 Serie Manual Del Operador página 19

Ocultar thumbs Ver también para 675 Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

Prepare your log splitter for storage at the end of the season or if the
log splitter will not be used for 30 days or more.
WARNING
WARNING: Never store the machine with fuel in the fuel tank inside
of building where fumes may reach an open flame or spark or where
ignition sources are present such as hot water and space heaters,
furnaces, clothes dyers, stoves, electric motors, etc.
NOTE: A yearly check-up by your local Sears service center is a good
way to ensure your log splitter will provide the maximum performance
next season.
LoG SpLITTER
1. Clean the log splitter thoroughly.
2. Wipe the log splitter with an oiled rag to prevent rust, especially on
the wedge and the beam.
ENGINE
IMPORTANT: It is important to prevent gum deposits from forming
in the essential fuel system parts such as the carburetor, fuel filter,
fuel hose or tank during storage. Also, alcohol blended fuels (called
gasohol or using ethanol or methanol) can attract moisture which leads
to separation and formation of acids during storage. Acidic gas can
damage the fuel system of an engine while in storage.
1. Drain the fuel tank. Always drain the fuel into an approved container
outdoors away from open flame. Be sure the engine is cool. Do not
smoke while handling the fuel.
2. Start the engine and let it run until the fuel lines and carburetor are
empty.
OFF-SEASON STORAGE
IMPORTANT: Never use engine or carburetor cleaner products in the
fuel tank or permanent damage may occur. Use fresh fuel next season.
3. Remove the spark plug, pour approximately 1⁄2 oz. of engine oil into
4. Replace the spark plug.
NOTE: Fuel stabilizer is an acceptable alternative in minimizing the
formation of fuel gum deposits during storage.
Please follow the instructions below for storing your log splitter with
fuel and stabilizer in the engine:
1.
2.
IMPORTANT: Do not drain the gas tank and carburetor if using fuel
stabilizer. Drain all the oil from the crankcase (this should be done
after the engine has been operated and is still warm) and refill the
crankcase with fresh oil.
oThER
19
cylinder and crank it slowly to distribute the oil.
Add stabilizer to the gasoline in the fuel tank or storage container.
Always follow the mix ratio found on the stabilizer container.
Run the engine at least 10 minutes after adding stabilizer to allow
the stabilizer to reach the carburetor.
Do not store the gasoline from one season to another.
Replace your gasoline can if it starts to rust.
Store the log splitter in a clean, dry area. Do not store it next to
any corrosive materials, such as fertilizer.
Wipe the equipment with an oiled rag to prevent rust.

Publicidad

loading

Este manual también es adecuado para:

247.77640