Publicidad
Idiomas disponibles
Idiomas disponibles
7
7B
7A
HOT
7 WATER SUPPLY CONNECTIONS
Connect water Supply Lines (7A) to Faucet Inlets (7B). Hot water supply lines go into left
inlet. Cold water supply lines go into right inlet. (Supply lines are not included). Please
follow manufacturer's instructions when installing supply lines.
8
8 POP-UP INSTALLATION
Install Pop-Up using separate instructions supplied with the Pop-Up assembly.
9
9 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below the sink.
ENGLISH
7B
7A
COLD
3
FAUCET FUNCTION
10
HOT
COLD
10A
10 VALVE FUNCTION
By lifting the Lever Handle (10A) up, the valve will be activated allowing water to flow.
The water flow will increase by continuing to lift up the Lever Handle (10A). By rotating
the Lever Handle counter-clockwise, the water temperature will decrease to cold flow
only. By rotating the Lever Handle clockwise, the water temperature will increased to
hot flow only.
MAINTENANCE & CARE
11
11E
11D
11C
11 FLUSHING & AERATOR CLEANING
After installation is complete, remove Aerator Housing (11A). Turn Valves (11B) on
and allow both hot and cold water to run for at least one minute each. While water is
running, check for leaks. To clean the aerator, disassemble Aerator Housing (11A) by
separating the Aerator Shell (11C), Basket (11D), and Washer (11E). Once parts have
been cleaned, reassemble by reversing steps.
OPEN
10A
11B
11A
Publicidad
