Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTION
Clean the base filter
1. Open the cover.
2. Unlock three locking levers and grasp the
filter handle.
3. Remove the base filter and clean it.
If there is too much lint on the filter, clean
it in water. Dry the filter thoroughly before
installing it back.
4. Clean the rubber sealing, both at the filter
and handle.
5. Re-insert the filter.
6. Lock three locking levers and make sure
that the levers are in correct lock position.
7. Close the cover until there is a click sound.
• The lint accumulated on the filter will block the air
circulation. Not cleaning the filter regularly will increase
drying time and energy consumption.
CAUTION
• Disconnect the power cord before cleaning
• Do not operate the dryer without the filter
• Clean the base filter after each cycle to prevent lint
accumulation inside the dryer.
Clean the heat exchanger
Do not touch the heat exchanger with
your hand, which may cause an injury.
WARNING
• As necessary, approx. once every 2 months, remove the
lint from the heat exchanger using a vacuum cleaner with
a dusting brush attachment.
• Clean the heat exchanger without applying any pressure.
Otherwise the heat exchanger could be damaged. The
dryer will not dry if the cooling fins are damaged or bent.
Filter Base
25
Publicidad
