Publicidad
Idiomas disponibles
Idiomas disponibles
5.- GAIN: input gain control. For the MIC microphone input (XLR) the range is from +20 dB to +64 dB, and
for the LINE input (6.3 mm jack) from -6 dB to +38 dB.
6.- HIGH: high pass filter with 10 kHz cut-off frequency.
7.- LOW: w pass filter with 30 Hz cut-off frequency.
8.- MIC (5 V DC): 5 V DC condenser microphone input, 3.5 mm TS jack plug.
9.- FX: selector of the channel send to the FX integrated effects processor. The effects are repeat (REPEAT)
and delay (DELAY) which are set from the respective potentiometers.
10.- CLIP: LED which lights up when the input signal level is too high. In this case, decrease the input level
with the GAIN control until the indicator light turns off or turns on occasionally. If you are using the
player and this indicator lights up on channel 3/4, turn down the volume on the player itself with the
and
buttons.
11.- VOL: volume control of the input channel that is sent to the FX integrated effects processor (DSP) or to
the MAIN MIX output.
12.- LINE-LS/PLAYER: input selector for channel 3/4: LINE line input and LIVE STREAM input or player and
PC.
13.- MAIN MIX - VOL: volume control of the MAIN MIX output.
14.- FX – REPEAT: control to regulate the ECO effect by repeating the input audio more or fewer times.
15.- FX – DELAY: control to regulate the delay effect by modifying the time between the original audio and
its repetition.
16.-
- VOL: monitor output volume control
17.-
: stereo monitor output for headphones, 3.5 mm stereo jack plug.
18.- Mixer operation indicator light.
19.- CLIP: indicator lights on the left (L) and right (R) channels when the MAIN MIX output level is too high.
In this case, decrease the level of the input or inputs that are causing it by means of the VOL control of
the corresponding channel until the indicator light turns off or turns on occasionally.
20.- SIG: Left (L) and right (R) channel indicator lights when signal is detected at the MAIN MIX output.
21.- Integrated player controls:
/ REC: a short press starts or pauses playback. A long press starts/stops the recording of the
a.-
MAIN MIX signal on the USB device connected to the front of the unit. During recording, you can
pause/resume recording with a short press of the
/VOL-: a short press skips to the previous song. And a long press decreases the volume of the
b.-
player.
c.-
/VOL+: a short press skips to the next song. And a long press increases the volume of the player.
d.- MODE/ : a short press switches the player mode. In USB mode, a long press changes the repeat
mode: repeat all (ALL) or repeat one song (ONE).
22.- Player information display.
23.- USB port for audio file playback.
24.- LIVE STREAM: line input and output for smartphone/tablet connection, 3.5 mm TRRS jack connector.
The signal from the connected device will enter the mixer on channel 3/4 if the input selector is in the
LINE/LS position and will receive audio from the rest of the mixer inputs.
25.- LINE OUT - MAIN MIX: MAIN MIX bus line level outputs, 2 x RCA and 2 x 6.3 mm jack connectors.
(PHONES).
button.
- 3 -
EN
Publicidad
