Publicidad
Idiomas disponibles
Idiomas disponibles
If an abnormality comes up, the hob will enter the protective state automatically and display
corresponding protective codes:
Error Code for Ceramic hob
Problem
E0 & repeated
beep sound
warning.
E1
The above are the judgment and inspection of common failures.
ATTENTION! To avoid danger, please do not disassemble the unit by yourself!
9.
Installation
9.1
Selection of installation equipment
Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5cm space shall be preserved
around the hole. Be sure the thickness of the work surface is at least 30mm. Please
select heat-resistant and insulated work surface material (Wood and similar fibrous or
hygroscopic material shall not be used as work surface material unless impregnated) to
avoid the electrical shock and larger deformation caused by the heat radiation from the
hotplate. As shown below:
Note: The safety distance between the sides of the hob and the inner surfaces of
the worktop should be at least 3mm.
L(mm)
APV1201 290
APV2303 290
Under any circumstances, make sure the hob is well ventilated and the air inlet and
outlet are not blocked. Ensure the hob is in good work state. As shown below:
Note: The safety distance between the hotplate and the cupboard above the hotplate
should be at least 760 mm.
Possible causes
Overheating protection:
the hob is over heated.
Open circuit failure of
thermocouple
W(mm) H(mm)
520
520
What to do
Stop cooking till the internal temperature back to
normal. Please contact after sales service to
check the hob if there is PCB failure.
Please contact after sales service.
D(mm)
50
46
50
46
14
A(mm)
B(mm)
270
490
270
490
X(mm)
50 min.
50 min.
Publicidad
