Publicidad
Idiomas disponibles
Idiomas disponibles
TURNING THE SAW ON AND OFF
Connect the unit to a power source with the correct
voltage and frequency (120V).
1. To start the motor, pull the switch (C) to the "ON"
position.
2. To stop the motor, push the switch to the "OFF"
position.
NOTE: Providing the pump's plug is inserted into the
pump plug receptacle on the motor, the pump will be
turned on when the motor is turned on.
USING THE SAFETY LOCK
When the saw is not being used, the ON/OFF switch
should be locked in the OFF position, using a long
shackle pad lock with a 3/16" diameter shank.
To lock the saw:
1. Insert the shackle through the hole located
underneath the switch and pass it all the way
through the lock tab on the switch and out the other
side.
2. Secure the lock.
3. Store the key in a secure place and away from
the saw.
OPERATION
12
12
(continued)
FIGURE 13
C
Publicidad
