Dmx Channels; Cleaning Of The Unit - IMG STAGELINE LSX-049SG Manual De Instrucciones

Examples for the start addresses 1, 21 and 104:
← place value
← switch number
Fig. 6 Start address 1: switch No. 1 to ON
Fig. 7 Start address 21: switches Nos. 5, 3 and 1 to ON
Fig. 8 Start address 104: switches Nos. 7, 6 and 4 to ON
The easiest way is to start from the highest possi-
ble place value and add the smaller values until the
start address results as a sum.
After adjusting the start address, the light effect
unit can be operated via the DMX controller.

7 Cleaning of the Unit

The glass pane (2) serving as laser outlet should
be cleaned at regular intervals, depending on impu-
rities caused by dust, smoke, or other particles.
Only in this case the laser light can be radiated at
maximum brightness. Prior to cleaning, discon-
nect the mains plug from the mains socket.
Only use a soft, clean cloth and a detergent for
glass. Then carefully wipe the pane dry.
For cleaning the other parts of the housing only
use a soft, clean cloth. Never use any fluid, it could
penetrate the unit and cause damage.
8 Specifications
Laser colour / wavelength / power / class
LSX-049SG: . . . . . green / 532 nm / 4.9 mW/ 3r
LSX-40SG: . . . . . . green / 532 nm / 40 mW/ 3b
LSX-80SR: . . . . . . red /
Power supply: . . . . . 230 V~ / 50 Hz
Power consumption: 25 VA max.
Ambient temperature: 0 – 40 °C
Dimensions: . . . . . . . 145 × 75 × 270 mm
Weight: . . . . . . . . . . . 1.6 kg
All rights reserved by MONACOR
may be reproduced in any form or by any means for any commercial use.
650 nm / 80 mW/ 3b
® INTERNATIONAL GmbH & Co. KG. No part of this instruction manual

8.1 DMX channels

DMX Value Function
Channel 1: laser beam on / off, line / dots
000 – 051 laser beam off
052 – 103 beam on, shapes in dashed form
104 – 255 beam on, shapes in dotted form
Channel 2: laser shapes
000 – 004 circle
005 – 009 semicircle, open at the bottom
010 – 014 semicircle, open at the left
015 – 019 wavy line
... ...
245 – 249 eagle head
250 – 255 blossom
Channel 3: rotation around the Z axis
rotation 0° → 359°
000 – 128
permanent rotation, slow → fast
129 – 255
Channel 4: rotation around the Y axis
rotation 0° → 359°
000 – 128
permanent rotation, slow → fast
129 – 255
Channel 5: rotation around the X axis
rotation 0° → 359°
000 – 128
permanent rotation, slow → fast
129 – 255
Channel 6: movement in the X axis
000 – 128 displacement in 129 positions
permanent movement, slow → fast
129 – 255
Channel 7: movement in the Y axis
000 – 128 displacement in 129 positions
permanent movement, slow → fast
129 – 255
Channel 8: redesigning
000 shapes always completely shown
redesigning, slow → fast
001 – 255
Channel 9: writing speed of laser
fast → slow
000 – 255
Note: Due to the high output power, the laser diode is sub-
ject to high stress and therefore only has a limited life. As for
all wear parts, no guarantee can be claimed for the laser
diode.
Subject to technical modification.
GB
11